broken paths

[schneid_p]

On the scenic sub activity pack by bob pickering I have tried two activities and on both I get at least one path that is broken. One was bnsf east and the other was westbound amtrak paths.

How do I fix this problem?


Thanks, paul

[OTTODAD]

Hi Paul !

That is usually the result of some track changes having been made in a path after the activity has been created.

Accept the error message in the AE and continue into the Path Editor. A RED line should indicate the broken path.

Note where a broken path ends and remove it's "Start Point". Then create it again in the same location, routing it through switches if necessary (take other exit) and place it's "End Point" where it stopped before.

O t t o

[drjoe]

http://steam4me.railpage.org.au/trainsim/tutorials/fixpath.html