ATC

[smace]

Is there a way to automatically turn ATC on with out stopping at a station or pressing the page down key?

[Wulf_9]

Don't think so....it always starts in manual so there needs to be at least one keystroke to switch ATC on.

Ciao

Saxon Locomotive Works - "The difficult we do immediately; the impossible takes a little longer"

http://www.zodiac-infosystems.co.uk/rail/bve

[Stooopid_person]

It can be done in the route file, like the Victoria line, it loads the route and the train is already ATC.

[smace]

Good point. I will have to look at the lines where ATC is both on an off. I thought it only came on or off at a station where the train stopped, but that line uses ATC very well. It would make a good pattern to follow, thanks.

[Stooopid_person]

>Good point. I will have to look at the lines where ATC is
>both on an off. I thought it only came on or off at a
>station where the train stopped, but that line uses ATC very
>well. It would make a good pattern to follow, thanks.

In the .sta command, one of the numbers mean ATC, ATS or ATS-P. I forgot which number meant which.
A hint, if you want to enter the platform at above 45km/h, push the .sta command back 75m.