Broken couplers on Horseshoe Route

[ConCat]

Thanks Derek, The coupler settings did the trick for me.

[derekmorton]

r0 is coupler slack.

Cheers

[Rich_K]

Thanks. I changed my setting to match yours except for one. Do you know what r0 does? My rolling stock has many different numbers for this function, some as high as r0 (10cm 15cm).

[derekmorton]

I use these figures and have no trouble,

Coupling (
Type ( Automatic )
Spring (
Stiffness ( 7.5e2N/m 4.4e6N/m )
Damping ( 9e5N/m/s 4.2e6N/m/s )
Break ( 1e8N 1e8N )
r0 ( 6cm 6cm )
)
CouplingHasRigidConnection( 0 )
Velocity ( 0.2m/s )
)
Coupling (
Type ( Automatic )
Spring (
Stiffness ( 7.5e2N/m 4.4e6N/m )
Damping ( 9e5N/m/s 4.2e6N/m/s )
Break ( 1e8N 1e8N )
r0 ( 6cm 6cm )
)
CouplingHasRigidConnection( 0 )
Velocity ( -0.2m/s )
)
Buffers (
Spring (
Stiffness ( 7.5e2N/m 4.4e6N/m )
Damping ( 9e5N/m/s 4.2e6N/m/s )
r0 ( 6cm 6cm )
)
Centre ( 0.5 )
Radius ( 1 )
Angle ( 0.5deg )
)

Cheers

[Rich_K]

As follows
Break 5.4e7N 5.4e7N
Damping 5e6N/m/s 5e6N/m/s (overkill I think)
DerailBufferForce 1000kN

[derekmorton]

>I've made the typical changes to the coupler break, damping, and DerairBufferForce settings in all of my rolling stock but I still get broken couplers.

These settings.

Cheers

[Rich_K]

What settings have you used?

Cheers

Not sure I understand your question? If you mean what settings do I use in MSTS, the answer is all sliders full right, everything on in display settings except no overhead wires, no specular lighting, and no high detail shadows.

This is the only route where the broken couplers are a problem for me.

[derekmorton]

What settings have you used?

Cheers

[Rich_K]

I've had the problem running Joe Lawrence's NS 567 activity dropping down the east slope just past South Fork. Not running train brakes and dynamics in notch 1.

This is the activity I have been running as well. I have broken couplers in several locations, both in dynamics and under power. I've tried different consists made up of different equipment with the same result.

I also had this problem with an activity I created myself.

[ConCat]

I've had the problem running Joe Lawrence's NS 567 activity dropping down the east slope just past South Fork. Not running train brakes and dynamics in notch 1.

[Curt C]

I've never expereinced any breaks on the route. Where are they breaking at?

[Rich_K]

I am having a problem with coupler's breaking and ending activity on Austin Yoder's Horseshoe Curve route. I've made the typical changes to the coupler break, damping, and DerairBufferForce settings in all of my rolling stock but I still get broken couplers. It only happens on this route.

Any suggestions?