Hope to get some help with this, I'm stuck.
I've drawn an NYC three searchlight signal on a mast for a gantry. The plan was to just replace the SL3abs_g shape with this one and then I wouldn't have to deal with the sigcfg or sigscr files. The problem I'm having is when I create the file for the route it shows up in sView as just three or four sets of polygons all parented to SIGNAL and HEAD1, 2, and 3 are not showing. The sim doesn't see any heads so the signal lights just sit below the surface at 0,0,0 of the drawing.
I've tried just about everything I can think of to get the parenting to work but nothing I've tried has worked.
A couple of years ago I tried to get a switchstand operating and the file did export properly with HEADs showing up in the hierarchy. Not this time.
Any ideas what's going wrong?
Paul :-)
I've drawn an NYC three searchlight signal on a mast for a gantry. The plan was to just replace the SL3abs_g shape with this one and then I wouldn't have to deal with the sigcfg or sigscr files. The problem I'm having is when I create the file for the route it shows up in sView as just three or four sets of polygons all parented to SIGNAL and HEAD1, 2, and 3 are not showing. The sim doesn't see any heads so the signal lights just sit below the surface at 0,0,0 of the drawing.
I've tried just about everything I can think of to get the parenting to work but nothing I've tried has worked.
A couple of years ago I tried to get a switchstand operating and the file did export properly with HEADs showing up in the hierarchy. Not this time.
Any ideas what's going wrong?
Paul :-)
Comment