Hi all! I'm fairly new to the Open Rails community, getting into it over the past few months. I've purchased a few items from TrainSimulations and I've been having a lot of fun with the simulator.
TrainSimulations products are great and their models are well detailed and look very good, but there is something I noticed about their EMD standard cab locomotives. The roof line is somewhat off, with a bit too steep of a slope on the engineer and conductor side. This can be seen in the attached screenshots when comparing two SD40 models.
This seems like it could be a relatively easy fix and as something of a tinkerer, I would like to have a crack at it.
So I'm wondering if anyone has some pointers as to the possibility of doing this and what might be required, such as the tools needed etc. A particularly important part of this would be obtaining permission from the creators.
Any information is appreciated. Thanks!
TrainSimulations products are great and their models are well detailed and look very good, but there is something I noticed about their EMD standard cab locomotives. The roof line is somewhat off, with a bit too steep of a slope on the engineer and conductor side. This can be seen in the attached screenshots when comparing two SD40 models.
This seems like it could be a relatively easy fix and as something of a tinkerer, I would like to have a crack at it.
So I'm wondering if anyone has some pointers as to the possibility of doing this and what might be required, such as the tools needed etc. A particularly important part of this would be obtaining permission from the creators.
Any information is appreciated. Thanks!
Comment