charland
Senior Member

Might want to download and run Malwarebytes. https://www.malwarebytes.com There is a free trial version that lasts two week before it turns...

Yes it is! MEGATHANKS to you and have a HAPPY HOLIDAYS!!!!!

I replied to this for a simple reason. The first time I ever downloaded anything here was a route. I followed the installation instructions and...

Hi Don, no problem with the date, note much room on a slide tp write everything down! Paul :-)

I don't think they made it west of Ontario. I have a picture of a couple here in Brockville in green and gold, but from what I've read they were in...

Must have gotten the shaft of life because here is a shot of 1800 alive and well at Fairview (the Halifax engine terminal) in June of 1976! ...

You're welcome, had fun building them! Paul :-)

No, it's like an MLW RS-23 with the cab moved forward 30 inches and the electrical cabinet moved to the short hood. It road A1A trucks and was 1400...

Used between Bridgewater and Bridgetown during the era I modeled the DAR in, so would be the power on the CN trains that came into Middleton. Paul...

And then there were three! Paul :-)

The frame is the same 41 feet that an RS-23 is made on, it looks like they just out a 30 inch short hood on one end with the electrical cabinet and...

First run of a Canadian National RSC-24 using trackage rights in Middleton. CN had 4 RSC-24s made, 1802 was destroyed in a head on accident in...

Both are available here: http://www.indianrailsim.com/database/list/author/Nitin+Bhandare/page2/ Paul :-)

Had to look that one up Chris! Stan Rogers Bluenose song is about the Schooner Bluenose, not the ferry! Paul :-)

Drew the MV Bluenose that ran between Bar Harbour ME and Yarmouth NS from the late '50s to the early '80s. 346 x 65 feet, 2857 ploygons. ...

Scott, Thanks

Scott, Both cars look great and I for one would love to have cars based on them. We both like pretty much the same routes and cars for them are...

And that is the precise reason why there are so few crossings and turnouts done for the DB- and UStracks range of shapes. Norbert had the same tools,...

Paul, I am glad to see that you have been able to extend the finished part of the route farther to the east through Yarmouth. It looks to be...