Can't see all locos ! Asset type.

[BigBravo21]

Sorry for asking such a stoopid Q ,I used to know this but have forgotten. I want to use a modern diesel loco on an unelectrified part of Isle of Wight, but all I can see is the two locos used oin the Isle of Wight. How can I see all my other locomotives ? For example, I might want to use an American diesel on the Isle of Wight. How can I get to see it to select it please ?

[mrennie]

Sorry for asking such a stoopid Q ,I used to know this but have forgotten. I want to use a modern diesel loco on an unelectrified part of Isle of Wight, but all I can see is the two locos used oin the Isle of Wight. How can I see all my other locomotives ? For example, I might want to use an American diesel on the Isle of Wight. How can I get to see it to select it please ?

Don't worry, that question gets asked quite often, probably because the answer isn't obvious

When you go into the scenario editor, there's a fly-out on the left. In the bottom left-hand corner of its header, there's an icon showing a blue cube with a yellow triangle (I think ... I'm talking from memory). Click on that and another flyout appears on the right of the screen. In there, you can see all the "products" of all the "developers" you have installed in TS2013. Just look for the one that contains your diesel and check the tickbox to make sure it's enabled. Then when you go back to the locomotive selection list, it should now appear.

Cheers,
Mike

[BigBravo21]

Aah thanks mrennie, That's got me going !

[mrennie]

Aah thanks mrennie, That's got me going !

My pleasure