Irregular TSM operation

[landnrailroader]

Colleagues,

I have created, successfully, perhaps 60 bridges for a new Knoxville Division
(L&N, CSX) route and needed 3 more in the Corbin, KY yard. Using parts
that have worked for many previous bridges, I created one and when I
generate the files for MSTS/ORTS all I get is a few parts of the original
parts, usually just the handrails to show in either TSRE, MSTS, or ORTS.
Anyone else see this phenomena, and if so, what corrected it.

Now remember, I used parts that worked successfully, many previous
times.

J. H. Sullivan
(landnrailroader)

[caldrail]

How complex is the final model? Could you break it down into two or more shapes and test them? That way you can start isolating what's wrong.

[landnrailroader]

i tried that and got the same results, so I just created the bridges from scratch, as I had the
dimensions, and voila, things worked. I had seen this before, once, while detailing out the
Milwaukee Road Coast Div. 2nd Sub. and the solution had been to just "try again with new
parts". These were very simple bridges, just a deck girder span with two parts, the bridge
and the handrail plus the end berms & piers.

J. H. Sullivan