Results 1 to 3 of 3

Thread: B&O Mountain Locomotives

  1. #1
    Join Date
    Aug 2002
    Location
    Orlando, Florida, USA.
    Posts
    29

    Default B&O Mountain Locomotives

    I purchased the B&O Mountain Sub but none of the locomotives are working. They show RPMs and engine sounds, but no amperes are generated. I've checked the circuit breakers and I think the isolation valve is in Run. I deleted the route and the mtnsub assets and reacquired through Steam. Still no power. This applies to all engine types. Any suggestions?

  2. #2

    Default

    Check the loco brake. Both train and loco brake were set on the scenario I just tried. I used the HUD to release the brakes and just like you mentioned, when I notched the throttle up the RPMs increased but no amps and no movement. I then looked down to the left and noticed the loco brake was on full and used the mouse to release it and amps started going up and the train started to move.

  3. #3
    Join Date
    Aug 2002
    Location
    Orlando, Florida, USA.
    Posts
    29

    Default

    The locomotive brake was the problem. Thanks for the response.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
-->