Results 1 to 4 of 4

Thread: Subtile disappearing in TSRE

  1. #1
    Join Date
    Apr 2020
    Location
    Bengaluru, India
    Posts
    56

    Default Subtile disappearing in TSRE

    I'm fairly certain I knew how to fix this before. I'm clueless now.

    I selected a sub tile, right clicked and chose 'toggle draw' after which the sub tile disappeared leaving a white patch. How do I select the sub tile so I can toggle it off again? I can select the sub tiles adjacent to it, but not the one in question.

    In other words, how can I revert 'toggle draw' from a sub tile? Especially since the sub tile cannot be selected after toggle draw is enabled.

    Edit: Adding a picture

    Swadesh
    Railfan from Bengaluru, KA, India
    My YouTube Channel: https://www.youtube.com/channel/UCVC...KA-9nsmib27ndg
    Happy simming!

  2. #2

    Lightbulb

    Hello Swadesh,

    I believe you should click select the two subtiles on either side of the problem tile while holding the [SHIFT] key pressed.
    This in effect selects all three sub-tiles. Then you may toggle all draw on or off.
    This is rather a hazy memory from when I was repairing the PRR-East route.
    There is a post of mine at ELVAS Tower in the Contributed Software section where I discussed this exact problem with GOKU and
    was provided with the answer.

    regards,
    Edit Add: Well! I found the ELVAS Tower post I referenced above:
    >===> http://www.elvastower.com/forums/ind..._1#entry231961
    cheers!
    v
    Last edited by Vince; 10-01-2021 at 06:56 PM.
    ............Vince ..............
    ...... Author NECv4 .......
    .... LIRR BUILD PHOTOS ....
    .............LIRR VIDEO.............
    ...... Eschew Obsfucation ......

    On the The Statue of Liberty in New York Harbor there is a Tablet. On it is written:
    "Give me your tired, your poor, your huddled masses yearning to breathe free,
    the wretched refuse of your teeming shore, send these, the homeless, tempest-tossed to me,
    I lift my lamp beside the golden door!"

  3. #3
    Join Date
    Apr 2020
    Location
    Bengaluru, India
    Posts
    56

    Default

    Thank you so much! I've fixed it now
    Swadesh
    Railfan from Bengaluru, KA, India
    My YouTube Channel: https://www.youtube.com/channel/UCVC...KA-9nsmib27ndg
    Happy simming!

  4. #4
    Join Date
    Apr 2003
    Location
    Silicon Valley, CA, USA.
    Posts
    3,432

    Default

    FWIW I just found this problem myself. Following the instructions posted here did not fix it but selecting all 4 adjacent tiles and then hitting Draw did work. The Draw button is found in the middle of the Properties window which is usually over on the left side of your screen.
    Dave Nelson

    Seldom visiting, posting less often that that.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
-->