TSUtil and ScriptFiles in in sigcfg.dat

[dforrestc]

When using TSUtil utilities in Route Riter it appears that the first entry only under "ScriptFiles" in sigcfg.dat is read and any other entries under "ScriptFiles" are ignored. Is this what is being done and is this the correct procedure? If this is so, much signal information is not read.

An example of the "ScriptFiles" entry in sigcfg.dat is given below:

ScriptFiles (
	ScriptFile ( sigscr.dat )
	ScriptFile ( sigscr-UK-RI.dat )
	ScriptFile ( sigscr-UK-RI-CUST.dat )
	ScriptFile ( sigscr-UK-R2-CUST.dat )
	ScriptFile ( sigscr-UK-R3-CUST.dat )
	ScriptFile ( sigscr-UK-R4-CUST.dat )
	ScriptFile ( sigscr-dummy-sem-link.dat )
	ScriptFile ( sigscr-LNER.dat )
	ScriptFile ( sigscr-BR-E.dat )
	ScriptFile ( sigscr-TINSLEY.dat )
	ScriptFile ( sigscr-DISTANCECONTROL.dat )
)

[dforrestc]

Can someone please assist.

If not, is there any discussion forum with the author of TSUtil?

[jovet]

FYI... I don't know about Open Rails, but MSTS only allows 8 ScriptFile entries should you be trying to maintain compatibility.